Carcase parts with a high panel thickness

All carcase parts, not only the fronts are produced of 19 mm thick
panels (instead of 16 mm) with a 2 mm thick carcase front edge.
Due to the thickness of the panels, the units have a better stability
and the fittings can be mounted easier.

All wall units are inside and outside optionally available in any front
colour. The wall units in front colour have a 19 mm thick back wall. 

Perfection also on the back wall of the unit. The 19 mm thick back
walls (for wall units) can be grooved and screwed upon request.

Wall units are safely mounted by means of metal rails. The suspension
bracket is located on the back wall and is not visible inside. 


 

To meet the highest requirements on stability, the carcase parts of
our kitchens, also the parts behind the front are produced from
19 mm panels. All back walls are 8mm thick and are grooved and
screwed. If requested, the back walls of the wall units can also be
delivered with a thickness of 19 mm. All carcase components are
coated on both sides and produced with edges all-round, the front
edges are always provided with a 2 mm thick ABS edge ensuring
perfect protection against shocks.  


 

The advantage of 19 mm thick carcase parts: The cabinets have a
much greater stability. Even with a maximum load, the shelves do
not sag. Any screws and fittings can be deeper mounted into 19 mm
thick carcase parts ensuring lasting durability.


Wall units are safely mounted by means of metal rails. The suspension
bracket is located on the back wall is not visible inside. When opening a
wall unit you can just see four small cover caps. 


müller|Küchen only uses the best fittings. Cabinet carcases come
with a 3 mm thick hole line. The discreet positioning of the built-in
fittings gives the inside cabinet also a sophisticated look.


Müller|Küchen
Adenauerstr. 13 | 33184 Altenbeken
Fon: 05255-9328-0 | Fax: 05255-9328-10